Skip to main content
BluINFO

Edit Elevator Hardware

BluSKY URL: https://blusky.blub0x.com/en-US/MercuryElevator

 

Overview

The Elevator Hardware menu is used to configure the hardware found inside of the Elevator car. This article provides instructions on how to edit existing Elevator Hardware.

Change the Relay Enabled Time

 Warning: You must re-sync the controller manually for this change to go into effect. 

  1. Log in and navigate to Elevator Hardware.  Main Menu-> Setup-> System Setup-> Elevator Hardware
  2. Select the entry you wish to edit from the list.
  3. Click the  button in the lower left side of the screen.
  4. Use the Relay Enabled Delay field to enter the correct waiting period in seconds.

​  

  1. Confirm changes with the saveBtn.png button.

Change the Floor Release Time

  1. Log in and navigate to Elevator Hardware.  Main Menu-> Setup-> System Setup-> Elevator Hardware
  2. Select the entry you wish to edit from the list.
  3. Click the  button in the lower left side of the screen.
  4. Use the Floor Release Time In Seconds field to enter the correct waiting period in seconds.
    • Note: The Floor Release Time is only used when someone releases the door from either the Mercury Test Tool or from the Elevator Control menu. 

​  

  1. Confirm changes with the saveBtn.png button.
  • Was this article helpful?